My ve sv6 sportswagon has it and i thought water was getting in cause i noticed the windcreen glass and roof has a gap u would think they would use a rubber molding in that gap area.
I finished doing the VE yesterday as I purchased the NEW Garnishes on both side of the screen and I hid that UGLY top of the screen with a Special black tape that you can use it under water.
If someone is interest go to BUNNINGS where they have the paint section and find where they have duct tape and look for
T REX Ferociously Strong Tape. Yes its called this, it come in Saturn black. Also comes with a small roll 48MM wide (can guillotine it in half width after you unroll it and make it 12mm wide) and 1.88mm long just long enough for the top of the VE Screen.
NOW be very careful using this
STRONG ADHESIVE TAPE that has a plastic covering behind to protect the
ADHESIVE Section so roll out the tape no more than 15mm wider that the total screen on both sides and cut it. Dont make the Mistake that I did I made to to long so at the other end I had 100 mm left over and when you peel the protection off and the last bit left over touched the Paint ONLY touch it, not pressed on at all it STUCK THERE and you cannot get it off as you might take the paint off with it even if you horizontally try to take if off..
I had to use eucalyptus oil and a cotton bud and soke it and it took 10-15 minutes to get that 2 inch section off. Also use a 6 inch ruler to apply it and if you have bubble here and they use a sharp pin and let the air out.
I have never seen a strong tape like this.