Welcome to Just Commodores, a site specifically designed for all people who share the same passion as yourself.
my 97 Senator runs the VT setup. I suspect that a 98 will run VT as it was well into production by then.For future reference in the pic is 2 actuators, Left is VS, Right is VT on...
I will still check the short lead to Actuator on my VS Ute (Series 2 '98) to see if it's the same plug that goes into loom as the later ones.
View attachment 256343
Did you specify RHF. There are 3 different applications. The p/n's seemed to change over the years, however, the RHF has a Green plastic rod. It is referred to as the 'Master'. The others are opaque white. Inside they are different except for the 2 rears. They are interchangeable between left and right (on rear). The RHF has a single micro-switch, whereas the LHF has two, and obviously a different sliding mechanism. The PCB's are also different. The front two have 5 input wires, although different pin assignments and designations (colours). Generally the RHF ends in *****865 and the LHF in *****866. The rears both have 3 input wires.Thanks, but I just purchased a reasonable priced one on eBay.
The one I just had delivered is the same as the one on the left (fortunately). Now just have to find out how to test it to make sure it works! Don't need it right away.For future reference in the pic is 2 actuators, Left is VS, Right is VT on...
Yes, it was a used one.Thanks, but I just purchased a reasonable priced one on eBay.