PWR346
New Member
Hey guys,
Ive gone ahead and purchased a set of mace 1.9 rockers and PAC 1219 springs, after ringing a couple of well known shops in town, they advised not to fit the rockers and do a cam, and stating the rocker geometry will be out. Well I'm a stubborn bastard, and i don't want to waste $400 bucks worth of parts, I'm going to fit them. If i get get an engine builder to check the swipe pattern on the valves and adjust if possible, and also check pushrod length, and fit new hardened correct length push rods if necessary, the geometry should be correct again?
Cheers
Ive gone ahead and purchased a set of mace 1.9 rockers and PAC 1219 springs, after ringing a couple of well known shops in town, they advised not to fit the rockers and do a cam, and stating the rocker geometry will be out. Well I'm a stubborn bastard, and i don't want to waste $400 bucks worth of parts, I'm going to fit them. If i get get an engine builder to check the swipe pattern on the valves and adjust if possible, and also check pushrod length, and fit new hardened correct length push rods if necessary, the geometry should be correct again?
Cheers