kyekye
New Member
- Joined
- Mar 24, 2015
- Messages
- 14
- Reaction score
- 1
- Points
- 3
- Age
- 30
- Location
- wodonga
- Members Ride
- VR Commodore / VS SII Calais hybrid
Okay ill give a detailed explanation of what's been done and what i'm trying to do and what i need help with / Errors i have
I have a VR Executive commodore, it was an auto but i have done a full manual conversion (Taken all the ecu and engine looms etc from my old write off factory manual)
Next i brought a VS SII calais that is also a write off,
I have taken all the body looms, dash, heater box, everything from the calais and done a transplant into the vr for the calais upgrades etc,
So far everything is working Except the car wont even try to crank, i have done a lot of looking and reading and cant find information on it as everyone is just like "No, you're not allowed to put the buick into a vs, etc etc"
from wiring diagrams i have looked at it shows that the body loom to ecu plug (9 pin Under dash plug) has 2 different wires between vr/vs
In the vr its the 12v Crank Signal wire
in the vs it is the brake fail light wire
even when i try to bridge the starter relay there is no crank attempt,
Everything else works, the fuel pump primes, security disables, power windows, door locks, all work
so far the only thing i haven't checked is the Warning light check relay (as it has a new 5 pin relay in there and should be good) and slip rings
i was hoping someone might have some info on a wire i have to move/change to get it to try and crank
Yes the car ran fine and started without fail before the transplant
TIA i would like to get her back on the road soon!
I have a VR Executive commodore, it was an auto but i have done a full manual conversion (Taken all the ecu and engine looms etc from my old write off factory manual)
Next i brought a VS SII calais that is also a write off,
I have taken all the body looms, dash, heater box, everything from the calais and done a transplant into the vr for the calais upgrades etc,
So far everything is working Except the car wont even try to crank, i have done a lot of looking and reading and cant find information on it as everyone is just like "No, you're not allowed to put the buick into a vs, etc etc"
from wiring diagrams i have looked at it shows that the body loom to ecu plug (9 pin Under dash plug) has 2 different wires between vr/vs
In the vr its the 12v Crank Signal wire
in the vs it is the brake fail light wire
even when i try to bridge the starter relay there is no crank attempt,
Everything else works, the fuel pump primes, security disables, power windows, door locks, all work
so far the only thing i haven't checked is the Warning light check relay (as it has a new 5 pin relay in there and should be good) and slip rings
i was hoping someone might have some info on a wire i have to move/change to get it to try and crank
Yes the car ran fine and started without fail before the transplant
TIA i would like to get her back on the road soon!