vn 5l manual in vs v6 wiring problem!

[Matts-97vs]

currently have everything mechanically plumbed up, I'm struggling with the wiring side of it. I have figured out the v8 engine loom wires and am trying to make a patch loom to join the v6 side which is located drivers side firewall (2 plugs, one 6 pin one 8 pin).
could anyone please help me figure out what these wires do?
The wire colours are :
orange
pink
green/white
orange/red
pink/blue
red/black
blue/red
green
brown/red
blue/white
light green/blue
green
brown
any help would be muchly appreciated

 

[_R_J_K_]

Why are you trying to join it to a V6 loom? Which ECU are you running?

 

[Matts-97vs]

I have a 5l manual ecu
I have the vn engine loom and was told would only need a patch loom to join the two

 

[Immortality]

Are you talking about the 2 plugs by the side of the fuse/relay box under the bonnet?

You'll need to track down wiring diagrams for each model.

 

[VK SL 3800]

A VS SIII V8 S-Pack :

Yellow Ended Plug at brake booster:

Red/Black- ECM + all times
Green/White- Fuel Pump Relay Control +
Pink- 02 sensor & canister purge solenoid + feed
Orange- Blank
Orange/red- EFI Relay Feed + (from pin 30 via fuse)
Pink/blue- Maf and Auto trans + feed

Grey Plug at booster:
Brown Red- To Tachometer
Brown- A/C + power in from dash and pressure switches to request Compressor
Thick Dark Green- A/C clutch + feed from Relay
Thin Dark Green- Temp Gauge
Blue/Red- Oil light
Light Green/black- A/C compressor Relay control (earths relay)
Blue/White- Condenser Fan Relay control (earths relay)

Battery Harness:

Purple/white- Start Solenoid +
Brown- Alternator light

Under Dash Plug:
Brown/white- Brake Failure (earthed wire through brake failure light switch if activated)
Pink/Black- Ignition + Feed
Purple/white- Speedo signal output
Blue- Power or economy mode button ( earth or open depends on mode selected)
White/Black- OBD2 plug,pin 6
Black/White- blank
Brown/White- Check engine light Earth side trigger
Red/Black- OBD2 plug, pin 9
Blank Hole- Trip computer feed on Engine side of harness.

I dare say that the Vehicle harness would be the same across both V6 and V8 models but you need work that out for yourself.

 

[Matts-97vs]

Yeah the v8 loom has 2 plugs that end near the fuse box
but the v6 has 2 plugs in the corner of the drivers side firewall
so there's a distance of roughly 30mm between the two

 

[Matts-97vs]

350mm sorry

 

[Matts-97vs]

Yeah I'd say they will be the same
I've nutted out most wires and they match up to what you've said so ill give that a crack. Cheers