azzfox
Braaap.
- Joined
- Sep 5, 2005
- Messages
- 1,388
- Reaction score
- 22
- Points
- 0
- Location
- Yarra Valley, VIC
- Website
- www.facebook.com
- Members Ride
- VE SS-V
Hey all. Quick question. Will an intermediate shaft from a VP fit a VN? As in are they the same length? Im thinking so, but better double check.
Reason is I had a bit of an issue when fitting the lower clamp (to rack). My VP manual specifies 23-30 Nm (17-22 lb/ft). So I tightened them to 20 lb/ft. I then noticed the clamp has bent right around the shafts with the bolts also bent. Oops obviously too much . I had a look at the shaft in our VP wagon to compare and noticed it only had one bolt with the shaft end acting as the clamp. I like that idea better. Less to go wrong .
Reason is I had a bit of an issue when fitting the lower clamp (to rack). My VP manual specifies 23-30 Nm (17-22 lb/ft). So I tightened them to 20 lb/ft. I then noticed the clamp has bent right around the shafts with the bolts also bent. Oops obviously too much . I had a look at the shaft in our VP wagon to compare and noticed it only had one bolt with the shaft end acting as the clamp. I like that idea better. Less to go wrong .