Vt ls1 starting issue

[Joshua.nm56]

Just completed an ls1 conversion on my vt and it won’t get spark an fuel pump won’t get fuel unless bridged
I’ve just linked a new key aswell but still nothing
Was thinking it could be a immobiliser issue but unsure
Everything is plugged in on the motor
I’ve been through the fuses and relays but no issues there I believe but still not luck

Just wondering if anyone may have had the same issue

Computer is now inside the car don’t think that could create any issue but

 

[Fu Manchu]

Go back and triple check the rewiring of the ECU. Check wire by wire. Make sure they are in the correct pinout location on the plug. Make sure any joins are made to the correct wire. Make a list/table of what you have. Colours and pinout locations.

 

[Joshua.nm56]

Go back and triple check the rewiring of the ECU. Check wire by wire. Make sure they are in the correct pinout location on the plug. Make sure any joins are made to the correct wire. Make a list/table of what you have. Colours and pinout locations.

It’s just weird because I haven’t touched the wiring the wiring in the car was out of my statesman

 

[Fu Manchu]

Ok. When you said you had the computer inside the car now, I assumed you had extended the loom to allow it and figured a poor connection or incorrect pinning had occurred.

Is it because the BCM and ECU are not yet linked?

 

[Joshua.nm56]

Nah I didn’t have to I managed to get it inside without extending the wires

 

[Forcedvp]

Is it because the BCM and ECU are not yet linked?