VX SS Commodore - My diary.

[vc commodore]

Those honeycomb bits would be a good candidate for a scan and 3D print of a small duct that clips in place of it.

I know a guy who might be able to do that but he would need the vent assembly sent to him to scan, print, refine design and get it fitting well. Then he sends it all back to you. Then he will sell them on eBay.

If @Chuckmeister wants to go that direction, I don't have a problem sending them to be done to help him out....It'll take a whopping 5 minutes to remove both....The indicators aren't hooked up

 

[Fu Manchu]

The guy is in Melbourne. He did the Crewman bumper brackets. He did the VE LED dust covers and the VZ SS dust covers for LED bulbs.
He did something else for me as well. Great guy.

 

[Chuckmeister]

Its been a while since an update. Finally have the engine, t-400 and arse end sorted, for what it is anyway.
I'm at roughly 550 rwhp atm which is still far short of the 600+ I was chasing.
So this year hopefully I'll get 3 inch exhaust sorted. Engine is supposedly choking pretty bad atm with 2.5 inch..
Going to do a rebel chip and dash and a enough more boost.
And do a flex fuel tune setup.
600 and I'll call barleeze on the power.
I'm also really tempted to get rid of the om-1's and try these wheels... 12 minutes in though...

On from here (2026) Is the bodywork.

edit on that...was talking earlier in this topic about cooling issues, air flow and bonnet scoops (and my refusal to get one) I'm thinking of getting a spare bonnet and maybe grafting a fg hump into one. Just a thought at this stage.