Were to run wires through firewall - for Temp gauge sensor

[SRaven]

Installing a SAAS water temp gauge to my VY 2004 Crewman.
Not sure were to run the sensor wire through the fire wall. Would appreciate any advice,

Regards
SRaven

 

[Immortality]

I used a bit of welding rod (with the flux removed), just sharpened the point and then pushed it through the side of the main wiring loom grommet in the firewall.

 

[losh1971]

I used a bit of welding rod (with the flux removed), just sharpened the point and then pushed it through the side of the main wiring loom grommet in the firewall.

Does the VY auto have a clutch grommet, like some of the earlier models?

 

[07GTS]

there is a small grommet on passenger side under/behind the glove box that isnt used

 

[SRaven]

I used a bit of welding rod (with the flux removed), just sharpened the point and then pushed it through the side of the main wiring loom grommet in the firewall.

Thanks I will check it out

 

[SRaven]

there is a small grommet on passenger side under/behind the glove box that isnt used

Thanks I will also check this out

 

[Immortality]

Does the VY auto have a clutch grommet, like some of the earlier models?

Probably but it comes out in a **** location close to the engine where there is a lot of heat and not ideal for electrical cables and also probably hard to access under the dash. It's not my preferred location.

 

[SRaven]

Does the VY auto have a clutch grommet, like some of the earlier models?

Found a small grommet under the horn which worked out perfect.

 

[SRaven]

there is a small grommet on passenger side under/behind the glove box that isnt used

Thanks 07GTS that was perfect . Wire is through much appreciated