tommytoan
New Member
- Joined
- Nov 9, 2008
- Messages
- 33
- Reaction score
- 0
- Points
- 0
- Location
- Perth
- Members Ride
- WB One tonner, 202, 4spd
Heyas,
I have had a few posts so far on here as im going through fixing my manifold and carb issues, you guys have been awesomely helpful.
There is a lot missing between my exhaust and inlet manifold (pics attached), they are supposed to be bolted together and have a gasket but im not sure if mine has had one for a while. Should I worry about this? I found this thread,
http://forums.justcommodores.com.au...8-1985/98995-202-inlet-manifold-question.html
Can any of the fuel/air mix travel down to this section that connects the inlet and exhaust? The holes where past studs or bolts went to hold these together are pretty rusted up and the holes on the exhaust look sealed.
Also, on my inlet manifold I have a sleeve missing which you can see in the pic. Im wondering if I need to be finding a new sleeve or if it is ok to be left as is.
again thanks for any help you can give and helping me learn!
I have had a few posts so far on here as im going through fixing my manifold and carb issues, you guys have been awesomely helpful.
There is a lot missing between my exhaust and inlet manifold (pics attached), they are supposed to be bolted together and have a gasket but im not sure if mine has had one for a while. Should I worry about this? I found this thread,
http://forums.justcommodores.com.au...8-1985/98995-202-inlet-manifold-question.html
Can any of the fuel/air mix travel down to this section that connects the inlet and exhaust? The holes where past studs or bolts went to hold these together are pretty rusted up and the holes on the exhaust look sealed.
Also, on my inlet manifold I have a sleeve missing which you can see in the pic. Im wondering if I need to be finding a new sleeve or if it is ok to be left as is.
again thanks for any help you can give and helping me learn!