GM TECH 2 Vetronix scanner & Genuine software GM

[Brett_jjj]

you mean have I got a power source going to it? then no
the way I have it set up is tech 2 to candi module to diagnostic port

The tech 2 gets its power straight from the diagnostic connector. No need to use a seperate power cable. I assume it would still get power this way with the CANdi module attached.

 

[bush_basha]

yep it powers up fine just in the diagnostic port. what I want to know is why when I plug it in, I get a abs, stability control fault messages / codes, and sometimes a contact dealer message.

 

[TazzI]

yep it powers up fine just in the diagnostic port. what I want to know is why when I plug it in, I get a abs, stability control fault messages / codes, and sometimes a contact dealer message.

Shouldnt be getting all those errors if your simply plugging in the tool, the tool wouldnt be requesting any information, simply listening to the cars chatter.

Wouldnt be surprised if you got errors while using certain functions as certain modules may be told to be quiet.. causing other modules to lose communication with them and throw errors.

 

[bush_basha]

haven't played with it for a week or so, but pretty sure as soon as its plugged in it'll bring up codes. same as my HpTuners when plugged in brings up a contact dealer message and I think the others as well.

 

[sixes]

I am looking at getting one of these units. Can anyone pass on a link so I can buy one at a good price please?

 

[Brett_jjj]

I am looking at getting one of these units. Can anyone pass on a link so I can buy one at a good price please?

A few guys on here including myself have purchased tech2 kits from here. Dont pay over $450 delivered for a kit. If you have trouble getting the proper aussie software card, I can help.

Wholesale tech2 Gallery - Buy Low Price tech2 Lots on Aliexpress.com

 

[sixes]

Thanks. Just seems a waste to have to buy another card.

Do you or anyone here have one they want to sell??

 

[ama.pythons]

Sorry to revise a old thread thwy wont link bcm or program key heads or ecm program ing with out tis approval which looks impossible atm this is my exp im shating for anyone considering it think again expesive for what it does

 

[Yortt]

I am new to this forum, I have just purchased a tech2 clone it appeared to be working fine untill through trial and error it appears I have deleted information off the Holden memory card. I turn tech2 on and get

System initialising

RTC fail (in the list of passes)

Download mode
RS232 connection
elaps waiting time (and it starts counting in seconds)

Is there a way the existing card can be reprogrammed
or do I have to buy a new card

Any help much appreciated!

 

[Yortt]

Appears to be working now I am new to this forum, I have just purchased a tech2 clone it appeared to be working fine untill through trial and error it appears I have deleted information off the Holden memory card. I turn tech2 on and get

System initialising

RTC fail (in the list of passes)

Download mode
RS232 connection
elaps waiting time (and it starts counting in seconds)

Is there a way the existing card can be reprogrammed
or do I have to buy a new card

Any help much appreciated!