Rear tyres stuck on

[Proman]

On me Vs the rear alloy wheels are stuck on, i can't get them off, why are they doing this, never had a problem with my Vn.... How should i go about getting them off?....bang them off? pry them with a bit of timber? and yes i undone the lug nuts lol :bang:

 

[Verynice]

Very common problem for them to get seized on. Best way is to get a rubber mallet and bang the wheel from the inside, out.

 

[CANYONERO]

i had a similar issue with a mates VK. we tried everything. last resort we left the nuts loose and drove it in a zigzag manner ( very slowly ) we had limited tools and needed to get them off the car.

i wouldnt recommend it.

 

[Verynice]

Commodore owners should buy and keep a rubber mallet in the boot. Mos people have no idea they will be stuck on, and if they get a puncture, good luck taking the wheel off in the middle of no where with no tools he he.

 

[CANYONERO]

Commodore owners should buy and keep a rubber mallet in the boot. Mos people have no idea they will be stuck on, and if they get a puncture, good luck taking the wheel off in the middle of no where with no tools he he.

use my method lol.

 

[Verynice]

"very slowly" zig zagging was it

 

[TrikkBen]

They will only be seized together by a 15-20mm ring, on the center where the spigot goes inside the wheel hub, get the boot in mate!!

 

[chevy_big_block_bro]

I had the same problem with my new SSZ wheels on the tonner. All I did was bash opposite sides of the tyre with the ball of my hand until it became loose. hard to explain without pics so I drew a little pic

Hit the stars lol

 

[CANYONERO]

thats is a killer pic mate

 

[deanos70]

sweet pic
yeh ive had to do that before sitting on my arse with the wheel nuts just loose, wheel just off the ground and kicking with the sole of my shoes 1 side at a time

just make sure you support it well and dont get underneath it