Replacement Part??

[BraydenCassar]

Hi all,
Just wondering if anyone know where i can get a replace part ( photo below)

Its coming off the pcv system on a ve s1 sv6 ly7 commodore.

I went to my local repco, and supercheap, and they couldn't help so any help is appreciated.

 

[krusing]

Where are you in Melbourne ?

Jollys Wreckers would be your best option !!!
As there is a SHIP load of VE's at all 3 sites.
$2 entry !

 

[VS 5.0]

$2 entry !

What !

 

[krusing]

What !

https://www.jollysupullit.com.au/

Check them out !

 

[BraydenCassar]

Thanks boys,
But im hopping for a New part, Ive spent too much time and money just to get a second hand part im going to replace in another 2 years.
Its a good option if i cant get brand new but I'm trying to get new so it will last another 20 years.

 

[_R_J_K_]

Just go to a dealership and ask them, they are realistically the only ones who will stock that specific part new - hoses other than coolant and radiator hoses aren't big in the aftermarket as typically they don't need to be replaced like the constantly expanding and contracting coolant hoses do. Could be a $5 part or it could be a $50 part. Or you could just use some silicon hose.

 

[chrisp]

Search for a PCV or breather elbow. There are aftermarket manufacturers that make lots of different shaped rubber hoses, so sometimes it a matter of search through some catalogues.

I did find this one though… https://www.ebay.com.au/itm/191847626258

 

[stick3]

i brought both elbow and genuine pcv hose from ebay couple of years ago
https://www.ebay.com.au/itm/1626053...Zn6q7FNP5gLFf7v5/KXjSHJvM=|tkp:Bk9SR9a38_6yYQ

 

[krusing]

i brought both elbow and genuine pcv hose from ebay couple of years ago
https://www.ebay.com.au/itm/162605343615?epid=21034416582&hash=item25dc08a37f:g:EeYAAOSwfOVZeCp4&amdata=enc:AQAHAAAAoAou9Osng8A6UGFUJ9VHHIWFlvHzgpz4jh+0N/Ps0jJd8oz0J39i2w4aKjYqPma5Zw8h/jh9dlSObqkzDViBpEM9Wg66XR9JvMVP3Q6udYATm/05SslbYiYvs8qkTgj1lYcHadgb61y1b5N3sPpiFwNXTtOpZzjrVzCRGl8yqCZouyMin3DOk+ZTORO/MmZn6q7FNP5gLFf7v5/KXjSHJvM=|tkp:Bk9SR9a38_6yYQ

I purchased the same in Nov 2021, as mine was so brittle and blocked.

The OP is after the elbow for the Purge Pipe inlet.

 

[Fu Manchu]

It comes off easy enough. Has a glue of some sort. Maybe an epoxy? It gets brittle and with a bit of a twist it cracks and the old elbow comes off the pipe.

The elbow in the earlier post is the one you need.
Also buy that linked PCV pipe set and get a spare too. Do the PCV mod while you are at it. There’s a walk through in the how to section of the forum.