Seal or rebuild sub box?

[Car Audio Factory Outlet]

haha I was getting disapointed when I wasn't getting square cuts, make sure the saw is square! a few degrees off made all the difference. Now I have one square side, will cut the rest when I can be bothered.

Thats the right attitude... it happens in the xmas season.... anyway best of luck with it.

Cheers

 

[matty88]

I got one panel square, and I can't get the other same sized panel to match.

 

[Car Audio Factory Outlet]

I got one panel square, and I can't get the other same sized panel to match.

Just take your time and you will be right

 

[matty88]

Can I clamp the two together and sand them till it's alright?

 

[Car Audio Factory Outlet]

I dont see why not, though if it is out a lot I would make the one that is out using the one that is right as a template. then plane it off.

Would be better

 

[matty88]

Nah it's down to within 1mm so annoying as it needs to be 100% spot on. Gives me somthing to do at home, though

 

[garfa]

keep the school box. gap fill it so it has no leaks and close the port. now TAKE YOUR TIME and build a nice box to your peference on the TS specs.

 

[Sir-Psycho-Sexy]

SIR.... all bow for SIR!!!! LOL

I was told you were the "BOG KING" :yeah:

APPLY liberally!!!!:w00t:

and then sand like HELL!!!!!!:wax: :whistling

WTF? i don't know you :shooting: :realangry

 

[Car Audio Factory Outlet]

WTF? i don't know you :shooting: :realangry

Having a dig it did not take you long

Though I guess that is why they call you Grenade!!

........... 10 second delay

LOL

 

[Tasmaniak]

Can I clamp the two together and sand them till it's alright?

Matty, thats perfectly fine to do. Often times thats how I build a box. I cut them both 1mm to big all round. The I use a medium grit and a couple of good heavy swipes and the thing is perfectly square. Mind you....Keep them LEVEL thats the only thing that can really go wrong here is. One thing I do when I've had a few drinks and I'm building a box is I'll pen in a line of EXACTLY where I want to be and then I sane the entire thing to that point.

Your going to need gap filler anyway. As you start to screw the panels to each other, run a bead of silicone inbetween the two panels and then screw it down.

Trust me on that one...you'll appreciate the silent box.

How long does the port need to be?