Uniqe home for a V6

[delcowizzid]

lol ari sounds like bad luck my mate just bought this one 1440 bucks later makes nice cages though http://www.oldholdens.com/images/toys/pipe bender/P1050947.JPG

 

[Project_HR]

I wish I could find one of those for 100 bucks !!!!

 

[delcowizzid]

meh make one if you were real keen can probably get templates

 

[Project_HR]

Naaah mate, not that keen. I only need a cpl of roll bar hoops bent for the altered and i'm done, won't need it again, so i'll get them bent up at Richmonds some time soon.

 

[Nzpure]

Bro good to see the kiwi's showing them how its done ehheheh. Good going keep up the good work.

 

[ari666]

im a kiwi...

 

[Kurtp]

yeah i bought one once, tried it on a coupe of bits of 2.5 inch, squished it. filled it with sand, squished it, heated up one side, squished it... then thought "maybe it just big stuff", so i put the smallest clamps in, got a piece of fuel hose... squished it.

then i gave it to a mate.

After reading the "stupid things you've done while working on your car" post, i'm really not suprised.

 

[Project_HR]

Still more thinking and planning going on at the moment, and not a lot of hands on stuff. I have started work on the roll bars now though, this will be slow and painstaking, because they have to meet spec for helmet clearance, driver protection and placement, yet still nice and tight so I don't rattle around too much if I tip it over!!!

 

[vk.jonno]

looooooooooooooksss gooood as!!!!

 

[ari666]

man, i am still amazed you can get those sorts of bends. i must have been doing someting really wrong with mine. lookin' mint