How are you reading/writing to the eeprom?
Regretfully i didn't take photos! To show how its done. But it isnt as hard as it sounds.
Steps as follows:
1- Take the headunit out
2- Take the Fascia Cover plate only!
3- Locate the EEPROM ( on the left hand side when looking at it from the front ) “D810”
4- Use SOP Clip and clip it on the eeprom “firmly”
5- Use ur eeprom programmer ( I used CH341A
6- Make sure it connected to the PC
7- open the programmer and choose the eeprom type which its ( 24C16)
8- Read the dumps ( make sure you save the dumps before making any changes! )
9- Locate the VIN slot on the dumps and Change to the car vin.