vs 304 ute wont start

[jaydee 1944]

Ihave not checked either fuses or relays nor found any fault codes will try that next thank you

found 1 blown fuse replaced but still no start

 

[jaydee 1944]

replaced 1 blown fuse but no different

 

[gtrboyy]

Assuming you bridge pins 5 & 6 correctly & no fault codes come up next would be to check/swap out

fuel pump/filters/fuel pressure
ignition module
coil

 

[jaydee 1944]

how or where do you bridge pins 5 and 6 it has new fuel pump coil ignition module have not checked fuel pressure {my last holden was a red motor FJ]

 

[gtrboyy]

Above brake pedal...it's one of first things to do on these things.

Do a search on forum & start again from beginning or you'll just go in circles.

 

[jaydee 1944]

I think this task is beyond me as I don't have the special tools required ie fuel pressure guage, and diagnostic thingymajig

 

[woteva]

I think this task is beyond me as I don't have the special tools required ie fuel pressure guage, and diagnostic thingymajig

No special tools required yet.
Diagnostic codes can be read with a paperclip

As it runs with start ya bastard, I would think it would be a fuel problem.

 

[jaydee 1944]

yes ok I can do that but at one stage my son had an eleco look at it and he said that the injectors had no pulse and that it was the ecu

 

[jaydee 1944]

Thanks lads for your assistance i'm sure i'll get there in the end.

 

[BlackVXGTS]

Check this post below on how to display error codes and post the results.

When you say that you have replaced "all related parts" can you be more specific.

https://forums.justcommodores.com.au/threads/checking-error-codes-vr-vs-revised.22307/