Vx series 2 wont start PLEASE HELP...

[Lomaz299]

Hey guys i brought a 02 vx pretty cheap wanst going something with motor or wireing. Ok i though.
Easy fix i have a going motor+loom , ecu, bcm, key fob. That ive just installed.

Bam still nothing.

Winds over fine. Fires then stalls straight away. I have checked fuel. To the extent of pulling rail off and winding over so i have injector pulse. I have spark at every plug. Checked for fault code (bridge 5+6) comes up normal. Security light isnt flashing. Wont even fire up with start u bastard ether base..

The motor was going when was pulled out changed.
Its driving me crazy and i just after some advise guys please this is my first post on here sorry if this is already listed in another thread.

 

[VT&VX]

Advice

I think you have a bad contact in key. Try pressing the unlock button on key while you are turning it to start the car.

That worked for a mechanic this afternoon.

 

[Lomaz299]

Have tried that also mate.

 

[accentstencil]

Is the security light in the mode switch flashing when you try to start it?

 

[Lomaz299]

Nah its not. Someone said to me last night that the cas might not throw a error code could that be accurate?

 

[Lomaz299]

I will try get a video of it today. And upload.

 

[chrisp]

You might want to read up on the ignition system. I’m assuming it’s a V6?

During cranking, the ignition module (which is under the coils) fully controls the ignition. Once the revs get over about 400 rpm or so, control of the ignition is handed over to the ECM. If it fires when cranking, and stalls soon after, it could be a ECM or security system issue as others have eluded to.

 

[Lomaz299]

The motor and ecu and bcm and key head were working fine in the other vx when i pulled them out.

 

[devilly]

First thing I would be doing is ripping off the dash and making sure the connector is plugged into the mode button properly.

 

[Lomaz299]

Just done that and it is the mode light flashes. But as soon as i unlock the doors or turn ignition on it stops