what did you do to your car today?

[corhijasna]

installed a couple off plastic interior plugs etc,looks all finished again now

 

[oska]

fitted 2 new bonnet struts was surprised to see that 1 new was strong enough to hold it up

 

[Turd Ferguson]

 

[Nut Kracker]

Pulled apart an old amp to get the covers powder coated.....
27 screws.......
Two weeks later.........:whistling:
Put it back together this morning and had NO screws left over. :yahoo::rockon:

 

[EYY]

Pulled apart an old amp to get the covers powder coated.....
27 screws.......
Two weeks later.........:whistling:
Put it back together this morning and had NO screws left over. :yahoo::rockon:

Must've done it wrong then


Anyway, I managed to pull the motor out of the ute last night. The new one will be going in within a couple of days

 

[commodore665]

did an upper manifold and throttle body clean , engine flush and oil change .

 

[GothicKidd]

Mid-way of installing a corvette servo, lost the retaining clip for the pin. bit devastated! was keen to finish it and do a transmission service...Hopefully I can find it when daylight comes back around...

 

[delcowizzid]

aquired vx ss front bar for the wagon

 

[Nut Kracker]

Mid-way of installing a corvette servo, lost the retaining clip for the pin. bit devastated! was keen to finish it and do a transmission service...Hopefully I can find it when daylight comes back around...

Tie a decent magnet to a piece of string and drag it around the floor.
It's amazing what you'll pick up.

 

[Brisbarnz]

Tried adjusting pan hard bar but dam thing wont budge.