Installing Cruise Control...

[mulligan-can]

Hehe, I haven't checked yet . Was just thinking as everything else is pretty much plug and play....

Ok, say the switch isn't there where would you find another? Assuming there are none at the local wreckers and that I can't get to the nearest decent sized city to check there (seriously man, living in FNQ is lame, I'm 80km out of Cairns and work keeps me away 95% of the time that the wreckers there are open...)

 

[88GreenVN]

If the loom is not in place you will need to buy a retro fit cruise control loom. Holden dealers should carry it.
The switch - Go to the Ebay online shops, easy as.

 

[1991_Vn2nV]

Speaking of this, I cant for the life of me find the plug for the cruise module yet it appears the wiring is all there at the switch block...

Also, theres no holes to screw the module in which means I have to drill

 

[88GreenVN]

I hope the plug is there! or no cruise control!

 

[mulligan-can]

In the VN where does the cable hook onto? In that pic there appears to be a bracket? It can't mount on anywhere else right?

 

[88GreenVN]

In the VN where does the cable hook onto? In that pic there appears to be a bracket? It can't mount on anywhere else right?

Yep you'll need a bracket:thumbsup:

 

[Bent_6]

Im about to do this aswell but because my loom doesn't have the cruise module wires im going to fit an entire VP Main Wiring Harness to make it look factory fitted.
I have run this past the Doc and am waiting for a reply as to how it will work.
If he agrees it is the way to go, i will post up the way i did it for you to see.
Just not sure when i will find the time to do it.

Steve

 

[markovr]

Heres a picture of it out of a book http://forums.justcommodores.com.au/attachment.php?attachmentid=6163&d=1127345326
Shows the buick type engine like in a vn but its in a vr but all the install is the same

 

[mulligan-can]

I seem to have a green wire coming off the cruise loom that ends in a little elbow sort of black plug thing. Where is it supposed to plug in? Its only about 50cm long and I cant find anything that looks right...

 

[88GreenVN]

I seem to have a green wire coming off the cruise loom that ends in a little elbow sort of black plug thing. Where is it supposed to plug in? Its only about 50cm long and I cant find anything that looks right...

Could be the connector for the anti theft swith/bonnet open warning switch. Cant recall if the VN's had such a thing.

Its mounted by the bonnet catch and there is a rubber stopper the closes the switch when the bonnet is closed properly.