SV666
The Commodore Enthusiast
- Joined
- Feb 2, 2010
- Messages
- 332
- Reaction score
- 1
- Points
- 0
- Age
- 36
- Location
- South Morang
- Members Ride
- VS EXEC SII
Hey all,
Today I installed some new globes for the SV6 very simplistic process the only thing that gave me some hardship was un-clipping that little wire retainer to actually get the bulb out! Got there in the end.
Then I got to the stage to change the fog lights, now looking at the engine bay it didn't seem possible performing the change over from up top. So obvious solution would be going from the bottom to get to them, just wanting to know is it a difficult process? by the looks of things from what I saw I would have to un-screw the plastics from right under the bumper (screws where you could install the lip kit) and bolt or two further in.
That's basically from what I have seen is there anything I should be aware about? the process itself? I did read the owners manual, it stated that part of the glob replacement that a holden dealer should carry out but I would like to try this out for myself if its do-able. And also would I need to put the car up on a hoist to perform this? ( don't have access to a hoist thinking of using the incline of the driveway would be enough).
PS: Changed globes to 5500w from opg.
Any help on this would be appreciated.
Cheers.
Today I installed some new globes for the SV6 very simplistic process the only thing that gave me some hardship was un-clipping that little wire retainer to actually get the bulb out! Got there in the end.
Then I got to the stage to change the fog lights, now looking at the engine bay it didn't seem possible performing the change over from up top. So obvious solution would be going from the bottom to get to them, just wanting to know is it a difficult process? by the looks of things from what I saw I would have to un-screw the plastics from right under the bumper (screws where you could install the lip kit) and bolt or two further in.
That's basically from what I have seen is there anything I should be aware about? the process itself? I did read the owners manual, it stated that part of the glob replacement that a holden dealer should carry out but I would like to try this out for myself if its do-able. And also would I need to put the car up on a hoist to perform this? ( don't have access to a hoist thinking of using the incline of the driveway would be enough).
PS: Changed globes to 5500w from opg.
Any help on this would be appreciated.
Cheers.