Front seat anchor torque

[HUX 90]

I need to remove the front passenger seat in my ute as I wish to install an amp under the seat. I would like to know what torque the bolts holding the seat to the chassis in should be tightened to? I know most people don't worry about torquing the bolts or just use some locktight on the thread when re inserting the seats.

I'm probably over thinking this a bit too much but I was just wondering if anyone knew the correct torque.

I have searched but I haven't had any luck

Thanks in advance

 

[Aussie Willy]

Just use the "two grunt" method.