Pedal box

[Journeycastro12]

It’s mounted in the clock spring.

Ahh okay copy that, and looks like a good idea for the glovebox soft opener

 

[Fu Manchu]

That link to the factory manual is going to get you through the tricky bits.

You need a computer to download it to. It’s a big file. Enable the side bar in the pdf viewer and you’ll be able to navigate the document.

 

[Journeycastro12]

That link to the factory manual is going to get you through the tricky bits.

You need a computer to download it to. It’s a big file. Enable the side bar in the pdf viewer and you’ll be able to navigate the document.

Already done and had a look through for what’s ahead, computer on standby haha

 

[Fu Manchu]

I used masking tape on the dash harness. Marked what each plug was for. There are big plugs going into modules and fuse panels in the foot wells, I wrapped them in bubble wrap which made things easier. They didn’t catch on anything, not get damaged.

 

[Journeycastro12]

I used masking tape on the dash harness. Marked what each plug was for. There are big plugs going into modules and fuse panels in the foot wells, I wrapped them in bubble wrap which made things easier. They didn’t catch on anything, not get damaged.

Just took the brake booster off, here’s how bad it is

 

[Fu Manchu]

Ooof.

 

[Journeycastro12]

Ooof.

Yup. I had a look it didn’t look like the brake booster leaked but I’ll get a new one anyway only 80-120$. I still have more of the dash to go. Im
Thinking for the surface rust wire wheel and use some rust prevention paint

 

[losh1971]

Use some rust converter after a quick wire wheel, just to stop that oxidation from starting again.

 

[Journeycastro12]

Use some rust converter after a quick wire wheel, just to stop that oxidation from starting again.

Definitely, just need to figure the best plan of attack atm

 

[Fu Manchu]

That’s what I did. Rust converter and then epoxy, then some colour and clear coat.
Masked up what I could inside and out.