Vn stalling - Fuel issue?

[gtrboyy]

Reset ecu disconnect battery?

Check earths front of block etc clean not rusty?

Then see if does it again after good drive.

 

[Turd Ferguson]

Done all that, throws code 22 straight away no matter what. Replaced the connector for the TPS as well.

 

[Pollushon]

You might need to trace it back to the ECU and check the pins. It's driving okay but you get a 22 yeah?

 

[losh1971]

Did you fit the plastic adapter with the new TPS?

 

[Turd Ferguson]

Did you fit the plastic adapter with the new TPS?

My TB didn't have one

 

[MikeC]

A bad TPS should throw both codes 21 and 22. If you are only getting 22 check that you are getting 4-6 volts between the grey and the blue wires to the TPS.

 

[losh1971]

My TB didn't have one

I suspect that's the problem.

 

[Turd Ferguson]

My understanding is series 1's don't from what Ive seen around.

 

[Turd Ferguson]

A bad TPS should throw both codes 21 and 22. If you are only getting 22 check that you are getting 4-6 volts between the grey and the blue wires to the TPS.

Old TPS was throwing code 21, this one is throwing 22, but neither did both.

 

[Pollushon]

The plastic adapter is for the L36 Eco. L27's don't have them, it's a different TPS. I think MikeC is on to it, there's a bad feed. If the car runs okay that also supports the theory