Wiring connectors and repair faulty wiring to Oxy sensor

[commodoredave]

VTII v6 no scharge or turbo

the wiring is coming from the loom/harness to the connector (into which connects the o2 sensor wire plug)
the signal wire (its a 2 wire) has a fracture quite close to the connector. The fracture is probably too close to be snipped and crimped. So will need to replace a length of both wires and solder in ( any alternative to soldering?) into a new two pin female connector. Has anyone done this before and are outfits such as jaycar able to supply the electrical parts.

 

[lout]

grab a connector and length of loom from wreckers
soldering is best way to repair as long as you shrink tube the repair
get dual layer shrink tube

Marine Grade Heat Shrink Tube Dual Wall Heat Shrink Tubing Glue Inside Fast Wrap | eBay

Find many great new & used options and get the best deals for Marine Grade Heat Shrink Tube Dual Wall Heat Shrink Tubing Glue Inside Fast Wrap at the best online prices at eBay!

www.ebay.com.au

 

[commodoredave]

grab a connector and length of loom from wreckers
soldering is best way to repair as long as you shrink tube the repair
get dual layer shrink tube

http://[URL]https://www.ebay.com.au...MI5cOajJTb_wIVuJlmAh0T1QU2EAQYBCABEgIDRfD_BwE

[/URL]

The female connector is not screwed. It seemed like a good opportunity to install a new connector. If a wreckers is a viable option for parts might as well reuse the existing connector. What are your thoughts?

 

[lout]

if you can extract the terminals from the connector, then just solder some "new" wires on