Drewie
Active Member
- Joined
- Jul 9, 2005
- Messages
- 987
- Reaction score
- 50
- Points
- 28
- Location
- East of Melbourne
- Members Ride
- VX SS (Original owner).
all i remember was the rev just kep going up by themselve to about 7500revs it wouldn't kick into gear, my hubby took his foot of the accelerator this woeful grinding noise started then a bang it waslike a tight rubber balloon gone too far
buto be told all prlimary test were ok and the cars running fine on 1st inspection to no two maine bearing on the crankshaft have been damaged but unrelated to the timing chain that was replaced 10 prior.....mmmmmmIm not stupid'
If it would not change gear and reved to 7500 rpm I would say you probably have an auto trans problem to start with and the fact it reved to 7500 rpm probably damaged the main bearings. So you would also need to find out why it did not change up a gear. You probably have two problems.