Leany76
New Member
- Joined
- Apr 27, 2016
- Messages
- 14
- Reaction score
- 7
- Points
- 3
- Location
- Adelaide
- Members Ride
- GLC63s AMG, 66 Impala, 69 C10 LT5/10, 55 Chevy
Hi
I have read most threads here but couldn't find what im lookin for to help me out. There are bits an pieces in other forums, but i think i have a unique case that im sure others have experienced.
Sorry in advance if asked before. Point me the thread if so.
Holden VS2 Ute Bench Seat Colum Auto - nothing special but helps tow my sons go-kart trailer around (LS - turbo soon)
I'll cut to the point ASAP:-
What i have done/changed/noted:-
What i have not done/think i need to do next:-
Looking for advise or next directions to check please
Regards
I have read most threads here but couldn't find what im lookin for to help me out. There are bits an pieces in other forums, but i think i have a unique case that im sure others have experienced.
Sorry in advance if asked before. Point me the thread if so.
Holden VS2 Ute Bench Seat Colum Auto - nothing special but helps tow my sons go-kart trailer around (LS - turbo soon)
I'll cut to the point ASAP:-
- Close doors (me outside) press lock button on key fob, locks passenger door only, not driver door
- Close Doors (me inside), press lock button on key fob, locks passenger door only, not driver door
- Press to unlock and Passenger Door unlocks, but nothing occurs on the driver side.
- With Actuator out of door (ie removed from the door lock) plugged in, when you move the green actuator up and down the passenger door unlocks and locks which tells me (i think) that the electrical system is talking to the other door thru the BCM)
What i have done/changed/noted:-
- New Actuator, same part number, same model, same side (I have read many forums discussion say that it doesn't matter what door actuator i use as its the BCM that works out what door is what)
- WD40 the locking mechanism - it moves freely
- Checked the wires going through the door - all wires are wrapped up well
- Checked the wires inside the door (not rubbing on widow winder mechanism - all good)
- New key fob and re-programmed, no issues
- Security light comes on when i lock the ute, and goes off when i unlock the ute. Ute starts no issues
- Driver door lock did work before
What i have not done/think i need to do next:-
- Checked the BCM unit under the dash (i have pulled it out to check the plugs on the side - they all look okay
- Not sure what the wiring does going to the external door handle - i suspect something to do with the dead locking (i don't dead lock the ute ever)
- Remove Battery terminals?
- Actuator is from wreckers, it was tested okay. Do i need to buy a new one at $250 plus :-(?
Looking for advise or next directions to check please
Regards