247kw? expected or what??

[PIR4TE]

Thanks for the tip, work closely with good Australian suppliers plus custom fabrication.
I've never seen this before:

A bit far away at the moment, will call about remote tune.

 

['ssv']

mods-A.S.E. pod type CAI,HSV tri y headers,200 cell hi flow cats,2.5 Lukey exhaust,MAF tune.good output for minimal outlay I thought

300 rwkw with pod, exhuast and tune?

 

[AD07]

mods-A.S.E. pod type CAI,HSV tri y headers,200 cell hi flow cats,2.5 Lukey exhaust,MAF tune.good output for minimal outlay I thought

Must be a very happy dyno.......
294rwkw for those mods is too high.
Those numbers are what you would expect fom a LS3.

 

['ssv']

An ls3 makes 300rwkw with them mods?

 

[Ian Johnston]

I would say very happy dyno as well, considering stock 6.0 VE would struggle to make 200rwkw.

 

[PIR4TE]

I would say very happy dyno as well, considering stock 6.0 VE would struggle to make 200rwkw.

Nah mate, about 10% off there. Maybe eight years ago, standard Series II is 220rwkW, L98 about same.

 

[Ian Johnston]

Even if 220 is correct(which I still doubt), thats nearly 80rwkw increase with very little done to it.
I would accept 300 if it has a cam, twin 3" exhaust including extractors, OTR, and tune.

 

[Reaper]

Nah mate, about 10% off there. Maybe eight years ago, standard Series II is 220rwkW, L98 about same.

I'm with Ian on this one. If you see more than 200RWKW on a stocker 6.0 then be happy. If it's significantly over that figure then be suspicious.

Even if 220 is correct(which I still doubt), thats nearly 80rwkw increase with very little done to it.
I would accept 300 if it has a cam, twin 3" exhaust including extractors, OTR, and tune.

Doesn't need 3" but yeah you are pushing it without a cam. I am just hitting 300 rwkw with a mild cam + otr + mid pipe (stock extractors/cats/rear bi-modals). I have sacrificed some top end for monster low-mid torque though.

 

[PIR4TE]

Just playing devil's advocate for a moment, it is possible at that rpm, reasonable CAI, 98, 1 3/4 headers tuned to that peak, and no... 3" cat would not make a difference.
So it is possible, just not probable mainly because as I pointed out MAF frequency would be wobbly scaled to 320 g/s.
Cam not required strictly speaking, but I found that you do need more lift (.525+) and tuned induction to hit those numbers.

 

[PIR4TE]

I'm with Ian on this one. If you see more than 200RWKW on a stocker 6.0 then be happy. If it's significantly over that figure then be suspicious.

Guys I know you both have experience here but seriously the L77 does 220rwkw out of the box. So did the L98 I'm told.