I have just fitted J-LED's Paddle Shift Kit & Module.
It all works perfectly
I had my concerns regarding the mentioned issues from Thorby, but everything went well and its working perfectly with no issues at all.
My car (VF SSV L77 2015) had the Purple Wire in the 3rd Spot on the Clock Spring Connector as well. I was instructed to remove that wire & replace it with the supplied Green Wire, in which I did.
The sequence I did the installation was as follows.
1. Fitted the JLED Module to the Gear Shifter as per instructions given to me in a booklet supplied (About Half an Hour)
2. Then Routed the 1x Green Wire around from the Centre Console to the Steering Column.
3. Pulled the Top Plastic Cover off the Top of the Steering Column to access the Clock Spring Connector and Pulled out.
4. Removed the Purple Wire from the Connector (Pulled it out).
5. Fitted the New Green Wire into the connector as per instructions provided, and plugged back into clock spring.
6. Took the car for a test drive - Tested the Manual Gear Stick Selection - was working perfectly.
7. Proceeded to take off the Steering wheel - **Disconnected Battery** - Removed Airbag, Disconnected all cables, Removed the Centre Bolt (Very Hard - Pain in the Ass) and then the horn assembly, steering wheel removal etc
8. Removed Trim/Controls from the old steering wheel & fitted to new Steering Wheel.
9. Replace the Steering Wheel onto car and fitted all components, Centre Bolt, Connectors, airbag etc.
10. Reconnected Battery and Started car.
11. Drove off & Tested the Shifters - They worked perfectly.
So I am not sure what the issue is with Thorbys, but I can assure everyone that it all worked perfectly on my car.
I was very Sceptical about this kit, but thought I would give it a chance, and its paid off.
I sent a couple of messages to JLED regarding the Purple Wire and was assured it all should work. Some cars apparantly have this purple wire, and most don't. This Purple wire issue was not included in the instructions, which is why I was a bit concerned. Probably should have included a supplementary addition to the instructions regarding this purple wire ie (if the connector has a purple wire in the 3rd hole - proceed with the following instrucion..) But it all worked in the end.
I am very happy with the outcome.
The Paddles work very well, much nicer to drive with these on.
I am going to add my comment as a new thread, as I don't think its fair that one person should affect this business and put people off purchasing his product.